Hub Installation Guide Ve rsion 1.030 31
Dimensions
• Dimensions: 8 in. x 8 in. x 2.25 in.
• Weight: 3.3 lbs.
Network
• Ethernet: 10/100/1000
• Bluetooth: BLE 4.2
• Wi-Fi: 2.4Ghz / 5Ghz (Selectable) 802.11 a/b/g/n/ac
• Cellular: 4G LTE Cat 1
• Zigbee 3.0
• DHCP
Power
• Class 2 Isolated, UL Listed Power Supply
• 2 Wire Supply Voltage: 12VDC, 2A
• Power over Ethernet: 802.3bt (30W+)
• Operating Power: 20W-50W (Max: 4A @12VDC, 2A @24VDC; Min: 1.75A @ 12VDC, 1A @
24VDC )
• DC input evaluated for UL294: 12V DC – 24V DC
• 4 Hour backup battery
Warranty
• 1 year limited warranty on electronic components
• 5 year limited warranty on mechanical components
Environmental
• Materials: impact resistant materials
• Temperature: Operating / Storage 0°C to 40°C (32°F to 104°F), Indoor Use Only
• Relative Humidity: 10% at 90%, non-condensing
Compliance
US
• FCC Part 15B / 15C / 15E / 22H / 24E
• UL 62368
• CEC/DOE
PTCRB
IEC62133 (Battery)
Specications
Canada
• IC RSS-210 / 139 / 133 / 132 / 130 / 102 (MPE)
• ICES-003
• NRCAN
Regulatory Compliance
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modications not expressly approved by the manufacturer responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
•
•
•
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
Note: The country code selection is for non-US models only and is not available to all US
models. Per FCC regulation, all WiFi products marketed in US must be xed to US operation
channels only.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.
To Next Page
Loading...
General