To Next PageTo Next Page
Need help?Do you have a question about the LATNEX AF-3500 and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Power Supply | 9V Battery |
| Type | Anemometer |
| Data Hold | Yes |
| Air Temperature Range | 0 to 45 °C |
| Air Velocity Accuracy | ± 3% + 0.1 m/s |
| Units | m/s, km/h, ft/min, mph, knots, °C, °F |
| Measurement Type | Air velocity and temperature |
| Resolution | 0.1 m/s for air velocity, 0.1 °C for temperature |
Press the middle button to turn on the EMF meter.
The device displays the startup screen upon activation.
Enter the measurement mode, specifically for Electric Field.
Press and hold the middle button for 3 seconds to power off the device.
In measurement mode, press the left button to activate data hold.
All measurement readings and functions are locked when data hold is active.
In the Data Hold mode, press the left button to return to normal measurement.
Cycle through brightness levels: Low, Middle, High, and back to Low.
Indicates functions for Electro Magnetic Field, Electric Field, and RF Electric Field.
Each independent key serves as a selection key for functions.
From measurement mode, press the middle button to access the main menu.
Use the right button 'Select' to move cursor and left button 'Enter' to confirm.
Press 'Menu' to return to the previous measurement mode if not proceeding.
Select between Gauss/mG or Tesla/µT for magnetic field measurement units.
Choose RF strength units: uW/m², mW/m², uW/cm², mV/m~V/m, mA/m, or dBm.
Select the display language from available options like English, Chinese, Japanese, Spanish.
Set the auto power-off timer for 1, 5, 10, 15, or 30 minutes.
Enable or disable the device's sound feedback.
Access software version and other device information.
