Figure 6
(Return to step 4 and input the code and then proceed)
9. Install the TF card from the tool into the supplied USB TF
card adaptor and insert into the USB port of the computer.
10. Reopen the Creader VII+ / Creader VIII update tool, select
the updates you would like to perform or click “Select
All”, and then click “Download” to start downloading. See
Figure 7.
Figure 7
11. Once all steps are complete, reinsert the TF card into the
tool and power the tool via USB cable (one end to Creader
VII+ / Creader VIII and the other end to the computer) or
via OBD II cable (one end to OBD II connector of Creader
VII+ / Creader VIII and the other end to the vehicle’s DLC).
A dialog box prompting you to upgrade will pop up on the
screen (See Figure 8), select OK button to proceed.
Figure 8
12.The registration process is now complete!
To Previous Page
Loading...
