Launch Creader VII+ User Manual

Follow the steps described as below to proceed
registration and update:
1. Go to http://mycar.x431.com/pad/landingPageIndexCrv.
action and click the“Updating Tool Download” icon. See
Figure 1-a or Figure 1-b.
Figure 1-a (For Creader VII+)
Figure 1-b (For Creader VIII)
2. Download and install the Creader VII+ / Creader VIII
update tool and launch the program when installed, a
screen similar to Figure 2 will appear:
Figure 2
3. In Figure 2, type in the serial number, which is located on
the back of the Creader VII+ / Creader VIII.
4. After the serial number is entered, click “Update” to jump
to the registration page. Enter the following information
and click “Submit” (refer to Figure 3).
Figure 3
(If you need the Register Code, please refer to Steps 5~8.)
(If you have the Register Code, directly proceed to step 9.)
5. The register code can be found in your Creader VII+ /
Creader VIII. Connect one end of the supplied USB cord
to Creader VII+ / Creader VIII, and the other end to the
computer.
6. After Creader VII+ / Creader VIII has powered up and
entered the main menu screen, move the highlight bar on
the “Help” icon (See Figure 4) and press the
button.
Figure 4
7. Select “Tool Information” (refer to Figure 5) and press the
button to enter.
Figure 5
8. The register code shown in Figure 6 is the register code
for inputting in step 4.
LAUNCH
Guide to Register & Upgrade

Launch Creader VII+ Specifications

General

Supported Protocols	OBDII, EOBD, CAN
Update	Yes
Connectivity	USB
Category	Scanner
Functions	Read/Clear DTCs, Live Data, Freeze Frame, I/M Readiness, O2 Sensor Test, On-Board Monitor Test, Vehicle Info
Supported Vehicles	Works on most 1996 and newer OBDII & CAN domestic and import vehicles
Update Method	USB
Compatibility	OBDII
Languages	English, Spanish, French, Russian, German, Portuguese, Japanese
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Power Supply	Vehicle OBDII interface
Weight	300g (0.66 lbs)

Summary

Register and Upgrade Guide

Initial Registration and Tool Download

Steps for initial registration, downloading the update tool, and entering device serial number.

Finding the Register Code

Procedure to access device information and locate the register code via the Help menu.

Software Update Procedure

Prepare for Update

Instructions for installing the TF card and reopening the update tool.

Download and Perform System Upgrade

Selecting updates, downloading software, and initiating the system upgrade.