MMDSP Debugger 2 7
©1989-2019 Lauterbach GmbH
CPU specific Commands
Data.LOAD.Elf Load ELF file
Downloads an ELF file to the target. Note that for MMDSP targets the debugger performs a soft reset for
setting the program counter to the program entry point at P:0x0.
Register.RESet Soft reset
Sets all registers to their initial value after a reset. This is done via soft reset of the core which may have
effects besides updating the contents of architectural registers.
Format: Data.LOAD.Elf <filename>
Format: Register.RESet
To Next Page
Loading...
