33
EN
PREPARING THE COFFEE
COFFEE DOSE PROGRAMMING
Measures are always programmed using the same
button; any other buttons are ignored. The pro-
grammed amount of brewed coffee can be changed
by repeating the programming.
Place the mug/cup as shown (see PREPARA-
TION FOR COFFEE BREWING).
Lift the capsule loading lever until it locks into po-
sition to open the pod fitting compartment.
Put a Lavazza capsule into the capsule fit-
ting compartment.
Lower the capsule loading lever to close the pod
fitting compartment.
Press and hold one of the two coffee delivery but-
tons. After about 3 seconds, the selected key will
flash and the coffee machine will enter the pro-
gramming mode.
Once the desired amount of coffee has been ob-
tained, stop supply by releasing the button.
If the programmed measure exceeds the maximum
allowed the machine will automatically stop deliv-
ery, the delivery button will blink and the last pro-
grammed measure will be saved in the memory.
If there is a power failure during programming, the
last programmed value remains in the memory.
If during a dose programming, water lack is indicat-
ed, the machine stops the supply and the dose be-
ing programmed won’t be saved.
Once filled the water tank, repeat the dose pro-
gramming procedure.
To Next Page
Loading...
