22
Before use
- Place the machine on a flat, stable surface away from heat sources.
- Connect the machine to a single-
phase, earthed, 230 V mains outlet
using the power supply cable (1).
- Make sure there is enough water in
the water tank (2), by checking
through the water level sight window
(3).
- In order to fill the tank with water, re-
move the cover (4) and remove the
tank from its compartment, or use a
container to pour water directly into
the tank. If the water from the tap is
highly calcareous, it is preferable to
use water low in mineral content.
1
2
3
4
To Next Page
Loading...
