To Next PageTo Next PageWhat to do if my Lavor INDEPENDENT 1900 Pressure Washer has loss of pressure?
If your Lavor Pressure Washer is losing pressure, the nozzle might be worn out, so try replacing it. Also, the filter may be dirty; in this case, check and clean it.
Why my Lavor Pressure Washer pump doesn’t reach the necessary pressure?
If the pump of your Lavor Pressure Washer doesn’t reach the necessary pressure, the water inlet filter might be clogged; clean it. If the suction/delivery valves are clogged or worn out or the lance nozzle is incorrect or worn out, contact an authorised service centre or check and/or replace the lance nozzle.
Why is the pressure fluctuating on my Lavor Pressure Washer?
If you notice fluctuating pressure in your Lavor Pressure Washer, it might be due to air intake. Ensure that connections and the locking ring are well tightened. If the valves are dirty, worn out, or stuck or the sealing is worn out, contact an authorised service centre.
How to fix a noisy Lavor INDEPENDENT 1900 Pressure Washer?
If your Lavor Pressure Washer is making unusual noise, check the intake pipes, as it might be due to air intake. Also check and clean the filter if it is dirty. If the valves or bearings are worn out, dirty, or blocked, or if the water temperature is too high, contact an authorised service centre or bring the temperature under 40° C.
What to do if water is leaking from the Lavor INDEPENDENT 1900 pump?
If water is leaking from the pump of your Lavor Pressure Washer, it is probably because the sealing is worn out. Contact an authorised service centre.
How to unblock a Lavor INDEPENDENT 1900 Pressure Washer lance?
To resolve a blocked lance on your Lavor Pressure Washer, clean the nozzle with the pin included in the unit.
Why is there water in the oil of my Lavor Pressure Washer?
If there is water in the oil of your Lavor Pressure Washer, it could be because the O-rings (water and oil) are worn out, in this case, contact an authorised service centre. Alternatively, if there is high moisture in the air, replace the oil with double the suggested frequency.
What causes water leakage from the head of a Lavor INDEPENDENT 1900?
If water is leaking from the head of your Lavor Pressure Washer, it could be because the seals or O-rings seal system are worn out. Contact an authorised service centre.
General| Brand | Lavor |
|---|---|
| Model | INDEPENDENT 1900 |
| Category | Pressure Washer |
| Language | English |
Explains the safety lock on the gun for preventing accidental use.
Details how to fill the detergent tank and connect the foam unit.
Describes how to equip and adjust the spray lances for different spray patterns.
Explains the function of the thermal valve for by-pass operation and cooling.
Covers water supply connection and initial steps for starting the engine.
Provides guidance on motor and pump lubrication, recommending specific oil types.
Advises periodic checking of the water suction filter to prevent clogging.
Offers recommendations for storing the machine for extended periods, including antifreeze use.
