To Next PageTo Next PageWhat to do if my Lavor INDEPENDENT 3000 has a loss of pressure?
If your Lavor Pressure Washer is experiencing a loss of pressure, the nozzle may be worn out and needs replacement. Alternatively, the filter might be dirty, requiring you to check and clean it.
Why is my Lavor INDEPENDENT 3000 Pressure Washer pump not reaching the necessary pressure?
The pump of your Lavor Pressure Washer might not be reaching the necessary pressure because the water inlet filter is clogged. Clean the water inlet filter to resolve this issue. Also, the lance nozzle might be incorrect or worn out; in that case, check and replace it.
Why is my Lavor Pressure Washer making so much noise?
Your Lavor Pressure Washer might be excessively noisy due to air intake. Check the intake pipes. Another potential cause is extreme water temperature; ensure it is below 40° C. Lastly, the filter could be dirty; inspect and clean it.
Why does the Lavor INDEPENDENT 3000 have fluctuating pressure?
If your Lavor Pressure Washer has fluctuating pressure, it could be due to air intake. Check that connections and the locking ring are well tightened.
What to do if my Lavor INDEPENDENT 3000 Pressure Washer lance is blocked?
If your Lavor Pressure Washer lance is blocked, it is likely that the nozzle is dirty. Clean the nozzle using the pin included with the unit.
General| Brand | Lavor |
|---|---|
| Model | INDEPENDENT 3000 |
| Category | Pressure Washer |
| Language | English |
Describes the safety lock on the gun for preventing accidental use.
Explains how to connect the lance with detergent suction.
Guidance on using the lance with different nozzles.
Covers the initial steps to start the machine.
Details on connecting the water supply to the machine.
Information about appliances equipped with a thermal valve.
Instructions for assembling the machine.
Instructions for lubricating the engine and pump.
Guidance on checking the water suction filter.
Recommendations for storing the machine during long periods.
