To Next PageTo Next PageWhat to do if my Lavor INDEPENDENT 2700 Pressure Washer has a loss of pressure?
If your Lavor Pressure Washer is experiencing a loss of pressure, the nozzle may be worn out and needs replacement. Alternatively, the filter might be dirty, requiring you to check and clean it.
Why is my Lavor INDEPENDENT 2700 pump not reaching the necessary pressure?
The pump of your Lavor Pressure Washer might not be reaching the necessary pressure because the water inlet filter is clogged. Clean the water inlet filter to resolve this issue. Also, the lance nozzle might be incorrect or worn out; in that case, check and replace it.
Why is my Lavor INDEPENDENT 2700 making so much noise?
Your Lavor Pressure Washer might be excessively noisy due to air intake. Check the intake pipes. Another potential cause is extreme water temperature; ensure it is below 40° C. Lastly, the filter could be dirty; inspect and clean it.
Why does the Lavor Pressure Washer have fluctuating pressure?
If your Lavor Pressure Washer has fluctuating pressure, it could be due to air intake. Check that connections and the locking ring are well tightened.
What to do if my Lavor Pressure Washer lance is blocked?
If your Lavor Pressure Washer lance is blocked, it is likely that the nozzle is dirty. Clean the nozzle using the pin included with the unit.
Why is there water in the oil of my Lavor INDEPENDENT 2700 Pressure Washer?
If you find water in the oil of your Lavor Pressure Washer, it could be due to high moisture in the air. Replace the oil with double the frequency that is suggested.
General| Max Pressure | 150 bar |
|---|---|
| Flow Rate | 450 l/h |
| Weight | 27 kg |
| Hose Length | 10 m |
| Water Flow | 450 l/h |
| Motor Power | 5.5 HP |
| Fuel Type | Petrol |
| Pump Type | Axial |
Explains common symbols used in the manual for user guidance.
Instructions for unpacking the pressure washer unit and checking for initial setup issues.
Key safety instructions covering operational, maintenance, and hazard avoidance.
Guidelines for placing and operating the pressure washer correctly.
Explanation of the safety lock on the gun and its function.
Information on connecting the water source, including safety warnings.
Initial steps for starting the engine and priming the pump.
Details on oil types and replacement intervals for the pump and engine.
Procedure for checking the water suction filter to prevent clogging.
Instructions for proper disposal of the equipment according to WEEE regulations.
Lists common faults, causes, and repair steps for the high-pressure water pump.
