What to do if pressure decreases and increases when the lance is turned on Lavorwash NPX XP Pressure Washer?
If the lance is turned on and the pressure values decrease and increase on your Lavorwash Pressure Washer, it could be due to a clogged or deformed nozzle. Try cleaning or replacing the nozzle. Another possible cause is that either the boiler coil or lance are clogged with limestone, in that case you should perform descaling.
Why is the pressure fluctuating on my Lavorwash NPX XP Pressure Washer?
If you experience irregular pressure fluctuations with your Lavorwash Pressure Washer, several factors could be responsible. The suction and/or delivery valves might be worn out, requiring you to check and replace them if needed. There might be foreign matter in the valves, causing them to function poorly, so inspect and clean them. Air suction could also be the problem, so examine the suction pipe. Lastly, worn-out seals could be the cause, so check and replace them as necessary.
How to reduce the noisiness of Lavorwash Pressure Washer?
If your Lavorwash Pressure Washer makes too much noise, it could be caused by several factors. Air suction in the system could be the reason, so check the suction pipes. Alternatively, the suction and/or delivery valve springs might be broken or worn down, requiring replacement. Foreign matter in the suction and delivery valves can also cause noise, so inspect and clean these valves. Worn-out bearings could be another cause, so consider replacing them. Finally, extreme liquid temperature can lead to noisiness, so reduce the liquid temperature.
What to do if Lavorwash Pressure Washer pump does not reach fixed pressures?
If the pump of your Lavorwash Pressure Washer does not reach the fixed pressures, check the suction pipes for air leaks. Also, inspect the valves and seals for wear and replace them if necessary.
What causes water filtrations from the drains in Lavorwash Pressure Washer?
If you notice filtrations of water from the drains between the casing and head of your Lavorwash Pressure Washer, it could be due to worn-out seals. You should replace the seals. Another possibility is a worn-out piston, which would also require replacement. Lastly, the O-ring of the piston cap might be worn out, so replace the seal.
What to do if Lavorwash NPX XP Pressure Washer motor hums but does not start?
If your Lavorwash Pressure Washer's motor hums but does not start, contact an authorised service centre.
What to do if Lavorwash NPX XP boiler does not start?
If you are turning on the burner switch and the boiler does not start in your Lavorwash Pressure Washer, it could be due to several reasons. There might be no fuel, so fill the detergent tank. The fuel filter could be clogged, so clean it. The fuel pump might be either blocked or burnt out, requiring cleaning or descaling.
What causes oil filtrations from the drains in Lavorwash NPX XP Pressure Washer?
If you notice oil filtrations from the drains between the head and casing of your Lavorwash Pressure Washer, it is likely that the O-ring seals of the casing are worn out. You should replace the seals.
Schematic representation of the machine's electrical system.
Schematic representation of the machine's hydraulic system.
Critical warnings and guidelines to ensure user safety and prevent hazards.
Procedures for initial setup and first-time operation.
Explanation of the Automatic Stop System functionality.
Guidance on obtaining repairs and original spare parts.
Terms and conditions governing the product warranty.
General| Brand | Lavorwash |
|---|---|
| Model | NPX XP |
| Category | Pressure Washer |
| Language | English |
To Next Page
