How to start Lawn-Boy Lawn Mower?
To get your Lawn-Boy Lawn Mower engine started, try the following: Fill the fuel tank with fresh gasoline. Move the throttle lever to the START/MULCHING ZONE position. Press the primer three times. Connect the spark plug wire. Clean the spark plug, check its gap, and replace it if damaged.
Why does my Lawn-Boy Lawn Mower start hard or lose power?
If your Lawn-Boy Lawn Mower engine starts hard or loses power, try these solutions: Drain and refill the fuel tank with fresh gasoline. Clean the gas cap vent hole. Replace the air filter element. Clean the mower discharge chute and the underside of the mower deck. Clean the spark plug, check its gap, and replace if damaged. Also, check the engine oil.
How to fix uneven cutting pattern on Lawn-Boy Lawn Mower?
If your Lawn-Boy Lawn Mower has an uneven cutting pattern, try these solutions: Place all four wheels at the same height. Sharpen and balance the blade. Change the mowing pattern. Clean the underside of the mower deck.
Why does my Lawn-Boy 10310 vibrate so much?
If your Lawn-Boy Lawn Mower or engine vibrates excessively, try the following: balance the blade, tighten the blade mounting nut, clean the mower discharge chute and the underside of the mower deck, and tighten the engine mounting bolts.
What to do if my Lawn-Boy 10310 Lawn Mower engine runs rough?
If your Lawn-Boy Lawn Mower engine runs rough, try these steps: Connect the spark plug wire. Clean the spark plug, check the spark plug gap, and replace it if damaged. Move the throttle lever from the SLOW to the START/MULCHING ZONE position. Replace the air filter element.
What to do if Lawn-Boy 10310 discharge chute plugs?
If the discharge chute of your Lawn-Boy Lawn Mower plugs, try these solutions: Move the throttle lever from SLOW to the START/MULCHING ZONE position. Raise the cutting height. Allow the grass to dry before mowing. Clean the underside of the mower deck.
Why Lawn-Boy 10310 will not self-propel?
If your Lawn-Boy Lawn Mower will not self-propel, try these solutions: Adjust the self-propelled cable and clean any debris under the belt cover.
Essential guidelines for safe mower operation and avoiding injury.
Specific safety precautions to follow while the mower is in use.
Procedure for checking and adding the correct amount of engine oil.
Safe practices for handling, storing, and filling the mower's fuel tank.
Step-by-step guide to starting the mower's engine using the primer and starter.
Instructions on how to safely stop the mower's engine using the control bail.
How to engage and disengage the mower's self-propelled function.
Steps for adjusting the mower's cutting height for each wheel individually.
Instructions for replacing the mower's air filter element.
Steps for draining and refilling the engine oil.
General| Engine Type | 2-cycle |
|---|---|
| Cutting Width | 21 inches |
| Starter Type | Recoil |
| Deck Material | Steel |
| Fuel Capacity | 0.25 gallons |
| Fuel Tank Capacity | 0.25 gallons |
| Wheel Size | 8 inches |
To Next Page
