How to fix Lawn-Boy SilverPro 10247 when engine does not start?
If your Lawn-Boy Lawn Mower engine won't start, try these steps: First, fill the fuel tank with a fresh gasoline-and-oil mixture. Then, move the throttle lever to the Fast position and press the primer three times. Ensure the wire is connected to the spark plug. Finally, clean the spark plug, check the spark plug gap, and replace it if damaged.
What to do if Lawn-Boy SilverPro 10247 Lawn Mower starts hard or loses power?
If your Lawn-Boy Lawn Mower engine starts hard or loses power, try the following: Move the throttle to the Fast position. Drain and refill the fuel tank with a fresh gasoline-and-oil mixture. Clean the fuel cap vent hole, and clean or replace the air filter element. Also, clean the lawn mower discharge chute and the underside of the lawn mower deck. Finally, clean the spark plug, check its gap, and replace it if damaged.
Why is my Lawn-Boy Lawn Mower vibrating excessively?
If your Lawn-Boy lawn mower or engine vibrates excessively, try the following: Balance the blade and tighten the blade mounting nut. Also, clean the lawn mower discharge chute and the underside of the lawn mower deck. Finally, tighten the engine mounting bolts.
What to do if Lawn-Boy SilverPro 10247 Lawn Mower discharge chute plugs?
If your Lawn-Boy Lawn Mower discharge chute plugs, try these solutions: Move the throttle lever to the Fast position and raise the cutting height. Allow the grass to dry before mowing. Also, clean the underside of the lawn mower deck.
How to fix Lawn-Boy Lawn Mower running rough?
If your Lawn-Boy Lawn Mower engine runs rough, make sure the wire is connected to the spark plug. Clean the spark plug, check the spark plug gap, and replace the spark plug if it is damaged. Move the throttle lever to the Fast position. Clean or replace the air filter.
Why Lawn-Boy SilverPro 10247 Lawn Mower does not self-propel?
If your Lawn-Boy Lawn Mower isn't self-propelled, check that the end of the cable spring is hooked into the drive bracket. You may need to adjust the self-propel drive cable or clean any debris from under the belt cover.
How to fix uneven cutting pattern on Lawn-Boy SilverPro 10247?
To correct an uneven cutting pattern with your Lawn-Boy Lawn Mower, ensure all four wheels are at the same height. Sharpen and balance the blade. Change the mowing pattern. Clean the underside of the lawn mower deck.
General safety instructions for operating the lawn mower.
Detailed steps for starting the lawn mower engine.
Instructions for safely stopping the lawn mower engine.
How to operate the self-propel feature of the lawn mower.
Guide to adjusting the lawn mower's cutting height for different grass lengths.
A table outlining maintenance tasks and their recommended intervals.
How to examine the mower blade for sharpness and wear.
Step-by-step instructions for removing the mower blade.
Technique for sharpening the lawn mower blade to maintain cutting angle.
Corrective actions for when the lawn mower engine fails to start.
General| Engine Type | 2-Cycle |
|---|---|
| Cutting Width | 21 inches |
| Deck Material | Steel |
| Start Type | Recoil |
| Engine | Lawn-Boy 2-Cycle |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge | Yes |
| Warranty | 2 years |
| Drive System | Self-Propelled, Rear Wheel Drive |
| Wheel Size | 8 inches |
To Next Page