LawnMaster GT1313 - Winding New Line Onto Spool

16
MAINTENANCE
WINDING NEW LINE ONTO A SPOOL (See Figs. 15-17)
■ Only use .065" replacement line.
■ You may wind new cutting line onto an empty spool.
■ Replacement packs of cutting line are available from dealer.
■ Remove the empty spool from the grass trimmer as described above.
■ Remove any remaining cutting line from the spool.
■ First feed 4 inches of cutting line into the two eyelets in the upper section of the spool as shown (Fig.
15).
■ Wind the cutting line onto the spool in the direction of the arrow. Make sure to wind the line on neatly and in
layers. Do not criss-cross (Fig. 16).
■ Feed cutting line into the two eyelets in the upper section of the spool as shown (Fig. 17).
■ If you want to use, operate as described above to x the spool on the grass trimmer. Do not forget to
release the cutting lines from the parking slot.
Use LawnMaster
®
replacement spool; part NO. RS0101
WARNING
Only use the appropriate type of cutting line.
Fig. 17Fig. 16
Fig. 15
6
6
6
6
7
7
7
1