LawnMaster M2EB1637M - Troubleshooting

22
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Handles are not in position.
The carriage bolts are not
seated properly.
Adjust the height of the handle
and make sure the carriage
bolts are seated properly.
The wing knobs are not
tightened.
Tighten the wing knobs by
rotating clockwise.
The mower does not start.
The power is off.
Check the socket, fuse, cable,
wire and plug and have any
repairs carried out by a qualied
electrician.
The power cord is not
connected to power source.
Connect the power cord to a
power source.
Tripped circuit breaker in the
house.
Reset house circuit breaker.
If it trips again, call a qualied
electrician.
Defective switch lever or safety
button.
Repair by a qualied person.
The grass is too long. Set a higher cutting height.
Jammed blade.
Stop the mower and disconnect
from the power supply, then
remove the blockage.
The motor stops.
The mower is blocked by
foreign object.
Remove the foreign object.
The mower cuts grass unevenly
or motor labours.
The lawn is rough or uneven or
cutting height not set properly.
Adjust the cutting position to the
height best suited for your lawn.
The blade is blunt. Replace the blade.
The blade area is blocked.
Clean the blade area and
remove the blockage.
The blade is assembled
incorrectly.
Install the blade correctly. Blade
wings should be facing up away
from the ground.
Only perform the steps described within these instructions! All further inspection, maintenance and
repair work must be performed by a qualied specialist.
Gloves and appropriate protective clothing must be worn when performing these instructions.
Always turn off the machine and disconnect the plug and wait until the blade stops before making
any adjustment.
WARNING