25
OPERATION
To advance the cutting line manually:
■ Stop the engine completely.
■ Push the spool cover in while pulling on the line, until you reach the desired length.
NOTE: After each use, clean the trimmer head with a damp cloth to remove dirt and grime.
CUTTING BLADE (See Fig. 28)
The trimming line cutting blade is attached to the underside of the debris guard (Fig. 28).
The cutting blade trims the line at a length that yields optimum cutting results. If the engine is running
faster than normal, or it appears as though the trimmer is less efcient, advance the line. This will
maintain proper performance and keep the line long enough to efciently cut the grass.
Fig. 27
Fig. 28
Trimmer Line
Cutting Blade
To Next Page
Loading...
