Need help?Do you have a question about the LawnMaster B261 and is the answer not in the manual?
General| Brand | LawnMaster |
|---|---|
| Model | B261 |
| Category | Trimmer |
| Language | English |
Contains important safety information, rules, and warnings for operating the LawnMaster Bent Shaft Line Trimmer.
Exhaust contains carbon monoxide, dangerous in confined spaces.
Engine sparks can trigger fires, especially near dry vegetation.
Petrol is flammable and explosive, causing severe burns or death.
Engine heat can cause severe burns; avoid touching hot parts.
Pre-use checks, safety labels, cooling, preparation, and general warnings.
Guidelines for safe operation, avoiding hazards, and initial setup.
Instructions for connecting the lower shaft to the main unit.
How to attach the handle assembly to the shaft.
Instructions for attaching the nylon cutting head.
How to attach the safety guard to the unit.
How to mix fuel and oil for the two-stroke engine.
Guidelines for storing fuel safely and procedures before refueling.
Procedure for draining fuel from the tank.
General rules for safe operation of the trimmer.
Important notes and essential checks to perform before starting the trimmer.
Step-by-step guide to starting the trimmer.
Adjusting the choke lever to the correct position for starting.
How to pull the starter handle to start the engine and warm up.
Accelerating, operating, and using the bump feed to extend the cutting line.
How to stop the cutting head operation by releasing the trigger.
Guide to using the nylon cutting head effectively and safely.
Various techniques for cutting grass and vegetation near obstacles.
Techniques for general trimming, mowing, and cutting near obstacles.
Technique for cutting vegetation down to the ground.
How to extend the cutting line using the bump feed method.
Step-by-step guide to replacing the cutting line spool.
Instructions for winding new line and installing the spool.
How to clean or replace the air filter for optimal engine performance.
How to check and clean/replace the fuel filter to prevent starting issues.
Schedule for air filter and spark plug maintenance based on usage hours.
Procedure for cleaning or replacing the spark plug for engine performance.
How to sharpen the cutting knife on the debris shield.
Keeping cooling air vents clean for starting and operation.
Information needed when ordering replacement parts for the trimmer.
Guidance on disposing of packaging and defective components.
How to properly store the trimmer after use to prevent damage.
Steps to resolve engine starting or running problems.
Troubleshooting tips for low engine power and irregular running.
Identifying causes for excessive engine smoke.
Addressing issues with the cutting device moving at idle.
Solutions for abnormal machine vibration.
How to handle overheating issues and ensure proper rest periods.
To Next Page