LawnMaster B261 - TROUBLESHOOTING GUIDE; ENGINE STARTING OR RUNNING ISSUES; LOW ENGINE POWER AND IRREGULAR RUNNING; EXCESSIVE ENGINE SMOKE

A STEELFORT PRODUCT
14
TROUBLESHOOTING
Before performing any maintenance or cleaning work, always turn off the engine and wait until the cutter has
come to a standstill.
THE ENGINE WONT START OR KEEP RUNNING
• Reassemble the nylon cutter.
• Check that whether there is no fuel or be used out.
• Incorrect starting procedure Follow the instructions
• Dirty spark plug or incorrect distance between the electrodes- Check the spark plug
• Air lter clogged- Clean and/or replace the lter
• Carburator problems- Contact local LawnMaster dealer
•
THE ENGINE STARTS BUT IS LACKING POWER
• Have nylon spool replaced - Contact local LawnMaster dealer
• Air lter clogged Clean and/or replace the lter
• Carburator problems- Contact local LawnMaster dealer
THE ENGINE RUNS IRREGULARLY AND LACKS IN POWER WHEN REVVED
• Dirty spark plug or incorrect distance between the electrodes- Check the spark plug
• Carburator problemsContact local LawnMaster dealer
THE ENGINE MAKES TOO MUCH SMOKE
• Incorrect composition of the fuel mixture- Prepare the fuel mixture according to the instructions.
• Carburator problems- Contact local LawnMaster dealer
THE CUTTING DEVICE MUST NOT MOVE WHEN THE ENGINE IS RUNNING IDLE
• Incorrect carburator regulation - Contact local LawnMaster dealer
•
THE MACHINE STARTS TO VIBRATE ABNORMALLY
• Damaged or loose parts- Stop the machine and disconnect the spark plug cable Inspect for damage.
Check for and tighten any loose parts. Have all checks, repair work and replacements carried out by a
LawnMaster Service Dealer.
IF THE TEMPERATURE OF MACHINES IS TOO HIGH
• Ensure the machines have rest at regular time.
• Faults which cannot be rectied with the aid of this table may be rectied by a LawnMaster Service
Dealer.