LawnMaster B261 - MAINTENANCE AND STORAGE; AIR FILTER MAINTENANCE; FUEL FILTER MAINTENANCE; MAINTENANCE SCHEDULE

A STEELFORT PRODUCT
12
7. Clip the housing back onto the line
trimmer
MAINTENANCE & STORAGE
It is the operator’s responsibility to complete all
scheduled maintenance and or servicing in a timely
manner. Always correct any issues before operating
the line trimmer. Follow all inspection and
maintenance recommendations that are listed in the
manual.
WARNING
Improper maintenance and or failure to correct
problems prior to operating the unit may cause the
unit to malfunction and result in property damage
and or serious personal injury. Improper maintenance
and servicing may void warranty.
During maintenance operations:
• Remove the spark plug cap.
• Wait until the engine is suciently cold.
• Never dispose of oils, fuel or other polluting
materials in unauthorized places.
Before performing any maintenance or cleaning
work, always turn off the engine.
1. Do not spray the unit with water. Ingress of
water may damage the engine and electrical
connection.
2. Clean the unit with a cloth, hand brush, etc.
MAINTENANCE SCHEDULE
12 hours of use 24 hours of use 36 hours of use
Air Filter Clean Clean Replace
Spark Plug Check Clean Replace
Expert inspection is required:
• If the grass trimmer strikes an object.
• If the motor stops suddenly
• If the nylon cutter is damaged
• If the nylon head connector is damaged.
Replacing and re-cleaning the nylon spool at the end
of the trimming season. Always re-cleaned the
nylon spool or, if required, replace the nylon spool
with a new one. Always have the nylon spool
re-cleaned or replaced by a LawnMaster Service
Dealer.
AIR FILTER
Accumulated dust in the air lter will reduce
engine eciency, increase in fuel consumption, and
allow abrasive particles to pass into the engine.
Remove the air lter as often as necessary to
maintain in a clean condition.
Light surface dust can readily be removed
by tapping the lter. Heavy deposits should be
washed out in suitable solvent.
Remove lter cover by loosening air lter cover knob.
NEVER run the engine without an air lter element
installed.
FUEL FILTER
Fuel tank is tted with a lter. The lter is situated
at the free end of fuel pipe and can be picked out
through fuel port with a piece of hooked wire or the
like.
Check the fuel lter periodically. Do not allow dust to
enter into fuel tank. Clogged lter will cause
diculty in starting engine or abnormalities in engine
performance.
When lter is dirty, replace the lter.
When the inside of the fuel tank is dirty, it can be
cleaned by rinsing the tank out with petrol.