A STEELFORT PRODUCT
9
NOTE: the “O/I” switch would always stays in “I” posi-
tion, please make it to “O” by hand
if needed.
2. Adjust the choke lever to (off / ) postion
3. When the grass trimmer is used and started for
the very rst time, the nal user is warmly
recommended to push the primer pump for 7
times at least, so has to obtain the best
performance of the equipment for future use as
well.
4. Pull the starter grip slowly for 10 - 15 cm until you
feel some resistance, then tug it a few times until
you hear the engine turn over, as following picture.
5. Adjust the choke lever to (on / ) position
6. Pull the starter handle until the engine starts
NOTE: Allow the engine running 1 minute to warm up
before starting working
7. Press trigger A to accelerate and operate
8. If use Nylon cutter, before cutting, need to bump
it to feed line rstly.
9. If you need stop cutting head working, release
the throttle trigger A and B. If any problem
occurs, press the engine switch, the machine will
stop running.
To Next Page
Loading...
