LawnMaster NPTGSP2617A - Fuel Mixture and Mixing Tips

20
GENERAL TROUBLESHOOTING
Flywheel (Rotor) Replacement (See Figs. 19-22)
Ŷ5HPRYHWKHFOXWFK
Ŷ5HPRYHWKHQXWXVLQJDQLPSDFWGULYHU)LJ
Ŷ5HPRYHWKHVFUHZVWRUHPRYHWKHÀ\ZKHHOFRYHU)LJ
Ŷ7KHÀ\ZKHHOFDQEHUHPRYHGE\DSXOOHU)LJ&KRRVHDQDSSURSULDWHSXOOHUWRUHPRYHWKH
À\ZKHHO%HIRUHXVLQJWKHSXOOHUURWDWHVFUHZURG
1
counter-clockwise till it is 1/4 to 1/2 its length
through. Ensure screw rods
2
and
3
are protruded longer than screw rod
1
. Rotate screw rods
2
and
3
clockwise into the corresponding threaded holes as shown in Fig. 21. Make sure screw rods
2
and
3
are level and in same length. Then use a spanner to rotate screw rod
1
clockwise until
WKHÀ\ZKHHOLVUHPRYHG5RWDWHVFUHZURGV
1
,
2
and
3
counter-clockwise to remove the puller
IURPWKHÀ\ZKHHO
Ŷ7XUQWKHFOXWFKXSVLGHGRZQDQGVOLGHWKHÀDWZDVKHUVRQWRWKHEROWV$SSO\WKHWKUHDGORFNLQJJOXH
for 3-5 screw threads and then re-install the clutch (Fig. 17 & 18).
Fig. 18Fig. 17
Fig. 19 Fig. 20