To Next Page

To Previous Page

THROTTLE AND STARTER SYSTEM

Ŷ&KHFNWKH3&%DVVHPEO\PLFURVZLWFKWKURWWOHVDIHW\DQGWKURWWOHOHYHU5HSODFHLIUHTXLUHG)LJ

59).

Ŷ8VHDSURSHUWRROHJDVFUHZGULYHUWRSU\RIIWKHPLFURVZLWFK

Ŷ2SHQWKHFRUUXJDWHGSLSHEXFNOHDQGGLVFRQQHFWWKHPDOHDQGIHPDOHWHUPLQDOVRIWKHPRWRUGULYH

lines (blue). Remove the motor drive lines of the handle part from the corrugated pipe. Remove the

PCB assembly by pulling it out of its slot (Fig. 60 & 61).

Ŷ5HSODFHZLWKDQHZ3&%DVVHPEO\DQGPLFURVZLWFK

Ŷ3DVVWKHPRWRUGULYHOLQHVRIWKHKDQGOHSDUWWKURXJKWKHFRUUXJDWHGSLSHDQGFRQQHFWZLWKWKH

motor drive lines of the engine part.

Ŷ5HVWRUHWKHPRWRUGULYHOLQHVRIWKHKDQGOHSDUWWKHZLULQJKDUQHVVRIWKHPLFURVZLWFKDQGWKH/('

cable into the slot as circled in Fig. 62. Align and re-insert the PCB assembly into the slot. Make

sure it is installed into place (Fig. 62 & 63).

Throttle

Safety

Microswitch

Throttle

Lever

Fig. 59

PCB

Assembly

Microswitch Wiring

Harness

Motor Drive

Lines of

Handle

Fig. 60 Fig. 61

Fig. 62 Fig. 63

LawnMaster NPTGSP2617A Service Manual

Other manuals for LawnMaster NPTGSP2617A