LawnMaster VBRM16-01 - Page 22

22
OPERATION
Cutting Modes
Auto Cutting
In Auto cutting mode, the robotic mower will mow the lawn in a random pattern.
After the robotic mower is powered on, press the Auto Mow Button for 2 seconds. Then press
WKH67$5721%XWWRQ$IWHUVHFRQGVRIFRQWLQXRXVUXQQLQJ\RXZLOOKHDUEHHSVWRLQGLFDWHWKH
blades have started to spin.
The robotic lawnmower will automatically search for a suitable working area. If the robotic mower
GRHVQRW¿QGJUDVVZLWKLQVHFRQGVLWZLOOFKDQJHGLUHFWLRQDQGVWDUWUXQQLQJDJDLQLQDQHZ
direction. The blades will not spin until the mower can run for continuously for at least 5 seconds.
Spot Cutting
In spot cutting mode, the robotic mower will mow in a spiral outwards from where it is placed on
the lawn. This is best used to tidy up any areas that may not have been mowed during a random
mowing session.
After the robotic mower is powered on, press the Spot Cutting Button for 2 seconds. Then press
WKH67$5721%XWWRQ7KHPRZHUZLOO¿UVWPRYHIRUZDUGDERXWWRFPWKHQVWDUWVSRWFXWWLQJ
FRYHULQJDSSUR[LPDWHO\VTXDUHPHWUHV$IWHUWKHVSRWFXWLV¿QLVKHGWKHURERWLFPRZHUZLOOVWDUW
to mow in a random pattern automatically.
If the area to be mowed is too narrow for the robotic mower to carry out the spot cut, after
continuous searching, the mower will mow in a random pattern automatically.
NOTE: Spot cutting is also a great feature to use before random mowing to systematically and
HႈFLHQWO\FXWWKHPDLQDUHDVRIWKHODZQE\GRLQJWKLVLWUHGXFHVWKHDPRXQWRIUDQGRPFXWWLQJ
WLPHQHHGHGWRFRPSOHWHWKHODZQ<RXDOVRJHWDEHWWHUODZQ¿QLVK
Setting the Cutting Height (See Fig. 17)
7KHFXWWLQJKHLJKWRIWKHPRZHUFDQEHDGMXVWHGIURP0,1PPWR0$;PP)LJ
'XULQJWKH¿UVWZHHNVRIPRZLQJDOZD\VVHOHFWWKHKLJKHUFXWWLQJKHLJKWPP$IWHUWKLVWKH
cutting height can be lowered step by step every week until the desired cutting height has been
reached.
Ŷ3UHVVWKH6723EXWWRQWRVWRSWKHURERWLFODZQPRZHU
Ŷ7XUQWKHFXWWLQJKHLJKWDGMXVWPHQWNQREWRVHWWKHFXWWLQJKHLJKW
- Turn clockwise to raise the cutting height.
- Turn anti-clockwise to lower the cutting height.
'RQRWPDNHDQ\DGMXVWPHQWWRWKHODZQPRZHUZLWKRXW¿UVWVWRSSLQJWKHPRWRU.HHS\RXUIHHW
away from the blade disc when adjusting its height.
WARNING