LawnMaster VBRM16 User Manual (English)

Other manuals for LawnMaster VBRM16

Questions and Answers:

J
Joshua MataAug 25, 2025
What to do if my LawnMaster VBRM16 Lawn Mower is stuck during mowing?
- B
  Brad GarrisonAug 25, 2025
  If your LawnMaster Lawn Mower gets stuck while mowing, there are several possible reasons and solutions: * Check the wheels and blade disc for grass or debris and remove any obstructions. * If the blade disc is in a pool of water, move the mower and prevent water from collecting in the area. * If the mower is caught on something, free it and remove the obstacle. * If it's stuck behind obstacles, remove them. * Level any uneven dips or hollows in the lawn with topsoil and grass seed. * If the lift sensor is activated, free the mower.
J
Jeffrey JacksonAug 25, 2025
What to do if LawnMaster VBRM16 is cutting grass unevenly?
- R
  randyboydAug 26, 2025
  If your LawnMaster Lawn Mower is cutting grass unevenly, consider the following: * If the working area is too big, adjust the border protections to decrease it. Recharge the battery to mow the area twice or purchase an additional battery. * Check if blades are dull and replace all the blades and screws. * If the height of cut is too low, or the grass is too high, increase the height of cut. * Check underneath the mower for grass wrapped around the blade disc and clear as necessary.
T
taylormariaAug 26, 2025
Why my LawnMaster VBRM16 Lawn Mower fails to start?
- M
  Mary McculloughAug 26, 2025
  If your LawnMaster Lawn Mower fails to start, check the following: ensure the isolator key is correctly installed, verify that the battery is properly installed, and make sure the battery is fully charged.
A
Andrew AllenAug 27, 2025
What to do if the cutting blade is not rotating on my LawnMaster VBRM16 Lawn Mower?
- M
  Michelle AshleyAug 27, 2025
  If the cutting blade is not rotating while your LawnMaster Lawn Mower is switched on, it may be due to an obstruction. Remove the isolator key and the battery pack, then clear any obstructions. Also, check if the blade screw is loose and tighten it.
D
Dawn MorenoSep 7, 2025
What to do if LawnMaster VBRM16 Lawn Mower is stuck during mowing?
- K
  Kayla LeeSep 7, 2025
  If your LawnMaster robotic lawnmower gets stuck while mowing, there are several possible causes and solutions: * Check the wheels and blade disc for grass or debris and remove any obstructions (always wear gardening gloves when handling the blade disc). * If the mower is in a pool of water, move it and prevent water from collecting in that area. * If the mower is caught on something, free it and remove the obstacle. * If the mower is stuck behind multiple obstacles, remove them. * Level out any uneven dips or hollows in the lawn with topsoil and grass seed. * If the lift sensor has been activated, free the mower.
K
Kyle CarpenterSep 5, 2025
What to do if charge control LEDs do not light up on LawnMaster Lawn Mower?
- K
  Kevin AdamsSep 5, 2025
  If the charge control LEDs do not light up after inserting the mains plug into the socket for your LawnMaster Lawn Mower, ensure the mains plug of the battery charger is fully inserted into the socket outlet. If the issue persists, check the socket outlet, mains cable, or battery charger for defects. If necessary, contact the After Sales Helpline.
R
Robert RobertsSep 6, 2025
Why LawnMaster robotic lawn mower runs outside working area?
- M
  Michael SalazarSep 6, 2025
  The LawnMaster robotic lawnmower might run outside the designated working area due to several reasons. It could be that the barriers defining the area are incorrectly set, requiring you to check and improve them. Alternatively, the ultrasonic sensors might be turned off, so ensure they are activated. Finally, if the working area has slopes steeper than 35%, you should delimit those areas.
R
Richard CrawfordSep 1, 2025
Why is there no charging procedure possible for LawnMaster VBRM16 Lawn Mower?
- T
  tsanfordSep 1, 2025
  If no charging procedure is possible for your LawnMaster Lawn Mower, it might be due to: * Contaminated battery contacts: Clean the battery contacts by inserting and removing the battery several times, or replace the battery. * Defective socket outlet, fuse, mains cable, or battery charger. * Faulty battery: Replace the battery.
N
Nathan RyanAug 30, 2025
What does it mean if LawnMaster VBRM16 error indicator is yellow continuous?
- M
  Marcus JohnsonAug 30, 2025
  A continuous yellow error indicator on your LawnMaster Lawn Mower suggests: * The lift sensor has been activated for 10 seconds: Remove and re-insert the isolator key, check for obstacles taller than 10 cm in the working area, and restart the mower. * The obstruction sensor has tripped 10 times in one minute: Remove and re-insert the isolator key, remove any obstacles, and check if the grass is too tall. If needed, mow the grass to below 60 mm with a conventional lawn mower, then restart the mower.
C
Cody PowellAug 31, 2025
What does it mean if LawnMaster VBRM16 battery indicator is red flashing?
- R
  rachelmillerAug 31, 2025
  A red flashing battery indicator on your LawnMaster Lawn Mower indicates: * Abnormal battery temperature: Allow the machine to cool down to a normal temperature, then restart the mower. * Electric core fault: Remove and re-insert the isolator key and restart the mower.

LawnMaster VBRM16 Specifications

General

Cutting Width	16 inches
Battery Voltage	40V
Deck Material	Plastic
Height Adjustment	6 positions
Type	Cordless

LawnMaster VBRM16 Original Instructions

Other manuals for LawnMaster VBRM16

Questions and Answers:

LawnMaster VBRM16 Specifications