Click “Next” and use the camera to scan the QR code in the
App on your mobile phone, when the sound “dong dong
dong” is heard, click “Notification tone heard.”, and then the
LED indicator will become solid blue after few seconds.
If you have multiple cameras, please follow steps again to
add devices one by one.
To change Wi-Fi network, please restore the camera to
factory settings and follow steps to add the camera.
Notice
EN
support@arenti.com
Scan the
QR code
of APP
If no device is found and the pairing process is not successful,
please refer to the following instructions:
1. Ensure that the Wi-Fi network is set to 2.4GHz.
2. Verify that the entered Wi-Fi password is correct and that
the mobile device is connected to the same Wi-Fi network.
3. Make sure the camera is in pairing mode.
4. Check for network activity on your Wi-Fi.
If none of the solutions work or if you have any other
issues, please contact support@arenti.com for assistance.
To Next Page
Loading...