LCD Concepts SL Series - Panel PC Components; Installation Procedures

8
Panel PC Components
The SL Series Panel PC packaging includes the following:
1. Panel PC
2. Power Cord
3. Manual
4. Recovery CD
Perform a Visual Inspection to the SL Series Panel PC. Check for:
 Obvious Shipping Damage
 Surface Flaws to the Enclosure or Monitor Screen
Contact LCD Concepts, Inc. Customer Service at 281-334-5181 if you find any damage to the
monitor.
Installation
SL Series VESA Mount Installation
The SL Series Panel PC is designed for 100 mm x 100 mm VESA Mounting using a wide
variety of commercial mounts available. See Appendix A for unit dimensions.
Before installing your Panel PC, make sure that the enclosure surfaces are clean and free of
debris.
The following steps will guide you through the SL Series VESA mount installation process:
1. Select the location for mounting the VESA mount.
2. Mount and secure VESA mount.
3. SL151PC: Use ¼ x 20 screws with flat and lock washers to mount the Panel
PC to the VESA mount, unit will accept 75mm x 75mm and 100mm x 100mm
VESA mounts.
SL191PC: Use 5/16 x18 Nylon locking nuts with flat washers to mount the
Panel PC to the VESA mount.
4. It is advisable to use a VESA mount that can be locked in place.
5. Torque mounting hardware to 7-ft/lbs. for 1/4x20 hardware and 11-ft/lbs. for the
5/16x18.