Rev: 04.08.19 Page 5
CCD-0002107
Operational Time Out
Any button held down for one continuous minute will cause a time out and all operation will cease. The
button must be released and then it or another button pressed to continue the operation. The purpose of
this feature is to minimize the risk of getting the camper dangerously out of level.
Idle Time Out
If no buttons have been depressed for two minutes, the system will shut down and the indicator light will
go out. Both the remote and the receiver will shut down. The purpose of this feature is to automatically
shut down the system when not in use. This reduces the possibility of tampering or accidental activation by
children or others.
1. Reset the remote by simultaneously pressing the All Up and All Down buttons (Fig. 1).
2. Reset the receiver by simultaneously pressing the ACC. IN and ACC. OUT buttons (Fig. 1).
Manual Jack Operation
In the event it becomes necessary to operate one or more of the jacks manually due to a malfunction of the
system or a dead or low camper battery, utilize this procedure.
1. Remove the protective weather cap and insert the hand crank handle into the crank socket on the jack.
2. Flip the motor release/locking lever on the side of the jack to the down position. This will disengage
the motor head from the jack, allowing it to turn freely by hand.
3. Manually raise or lower jack to the desired position.
4. Return the locking lever to the up position when not hand cranking. This engages the motor and
provides a secure lock for the jack.
5. Remove the crank handle.
Troubleshooting Table
Just as when using the remote feature, take care to keep the camper relatively level and do not
allow the front of the camper to become lower than the rear.
What Is Happening? Why? What Should Be Done?
Remote will not turn
on. No green light.
Dead or weak battery in
remote unit.
Remove six screws from back of remote and
replace AA battery.
Plug in coiled phone cord between remote and
receiver until battery can be replaced.
Defective remote. Replace remote.
Green light on
remote but jacks will
not operate.
Receiver needs reset. Simultaneously press ACC. IN and ACC. OUT.
Insufficient power to
operate jacks. (Red light on
receiver panel.)
Charge camper battery or plug into AC power, if
available.
One or more jacks
will not operate.
Blown fuse(s) on receiver
board.
Replace blown fuse(s). If fuses continue to blow,
contact LCI.
To Next Page
Loading...
Need help?
General
