USER INSTRUCTIONS
Lighting the Pizza Oven. Make sure all gas connections are securely tightened.
Check that the gas cylinder/regulator is turned on.
This Pizza Oven is equipped with automatic ignition, push the knob in and turn anticlockwise to
high position. You should hear a clicking sound from the igniter.
The knob has three basic positions. You can achieve any flame height between low and high by
rotating the knob between these positions.
The oven will reach +400 degrees Celsius in approx. 30 minutes.
(The test of the oven is performed in clear quiet weather with an ambient temperature of 15
degrees Celsius)
The Pizza oven must NOT be used as a heat source and should only run when cooking, the oven
will get overheated if it runs continuously on full power.
Before cooking, turn on the oven for 25-30 minutes at full power to heat up the stones. When the stones
are heated up put the pizza in the oven and turn it down to a low flame, this gives the best result. Turn up
to full flame again between the pizzas.
Burner OFF
Burner HIGH Burner LOW
8. When finishing cooking, leave the Pizza Oven on high position up to 5 minutes so that remaining
grease from the food will be removed.
9. When turning o the Pizza Oven, close the main supply from the gas cylinder first; this will allow
the remaining gas in the hose to evaporate. The burners can then be turned o.
10. Always ensure that the Pizza Oven has cooled down before cleaning. Hot surfaces may course
serious burns or injuries. If the Pizza Oven is still hot use gloves for protection.
NOTE: Blowback is a situatio
n where the flame burns inside the burner, towards the front. This can be
recognized by a sharp roaring sound coming from the burner. It is not dangerous. If this occurs, simply
turn o the burner, wait a few seconds and then relight.
MANUAL IGNITION
If the battery is low on power, it is possible to manually light the Pizza Oven.
Place a lighted match or gas lighter on top of the burner. (not provided)
Keep your hand below the bottom of the burner while doing this.
Turn the
You should see the burner ignite.
Once the burner has ignited,
If the burner does notcontinue to hold the knob for approx. 15-25 seconds before releasing knob.
light on first attempt, return the knob to o position,
control knob to HIGH position.
5. The above procedure should only be performed with extreme caution.
.
15
To Next Page
Loading...
