ASSEMBLY INSTRUCTIONS
STEP 2:
Put the stone (part 3) into the body as shown in the figure below.
STEP 3:
Connect to the gas cylinder. Your pizza oven can be used with propane gas.
The gas cylinder must be positioned at ground level on a flame proof
surface. The connection between the gas-cylinder and the pizza oven is made
with a regulator.
It is important to always use a regulator made for the type of gas you purchase.
STEP 1:
Place the leg (part 2) over the bottom plate as shown and fasten it. Put the AAA
battery (battery is NOT included) into the battery box as shown in the figure
below.
STEP 2:
Put the stone (part 3) into the body as shown in the figure below.
Place the leg (part 2) over the bottom plate as shown and fasten it. Put the AAA
battery (battery is NOT included) into the battery box as shown in the figure
below.
STEP 2:
Put the stone (part 3) into the body as shown in the figure below.
control knob to HUGH control knob to HIGH position.
9
To Next Page
Loading...
