The main switch should always be kept in the “ON” position during operation.
Before starting the engine, be sure to turn the switches of the working instru-
ment (lighting apparatus, motor, etc.) to their “OFF” position. If the switches
are not “OFF”, the sudden application of load when the engine is started
could be very dangerous.
3.5 How to open the cabinet door and covers of - - LDE series
generating set
1. Open the cabinet door for daily inspection.
Turn the lever counterclockwise and raise
the door
2. Loosen the bolt of the air cleaner check
port cover to check the air cleaner.
3. Screw off the wing nut to open the cover.
then check the nozzle cover.
3.6 Break-in period operation
The first 20hrs are the break-in period of the engine, the operator must obey to
following items:
Warm up the engine 5 minutes after the initial starting. Run the engine at low
speed and zero load before the engine becomes warm.
Avoid applying any heavy loads during the break-in period.- - recommends to
run the engine at 3000r/min with 50% load in break-in period.
Replace the engine oil on time.
Replace the engine oil while the engine is warm after 20-hours-running, the old
engine oil will be drained out completely.
Approx. one month or 20hours Every 3 months or 100 hours
To Next Page
Loading...
Need help?
General
