Leading LDE6800T User Manual

1. Disconnect the load from the generating set.
2. Turn off the air switch of the generating set,
3. Set the speed lever at “RUN” position, run
the generating set without load for about 3
minutes. Do not stop the engine suddenly,
otherwise the temperature will increase
abnormally, the nozzle will blocked and
the generating set will be damaged.
 Press down the stop lever.
 Concerning the electric starter, turn the key
to “OFF”.
 Turn the fuel cock lever to “S” position.
 Pull out the recoil starter handle until you feel
resistance (at this position, both intake/ex-
haust valve are closed. ) and leave the handle
in this position. This prevents the engine from
rust.
WARNING
 If the engine keep on running even after the speed lever is placed at the
“STOP” position, either turn the fule cock to the “CLOSE” position or loosen
the nut of high pressure fule pipe on the pump side to stop the engine.
 Do not stop the engine with the decompression lever.
 Do not stop the generating set with load. Stop it after the load removed
8. PERIODIC CHECK AND SERVICE
Periodic check and service are very important for keeping the engine in good condi-

Leading LDE6800T Specifications

General

Brand	Leading
Model	LDE6800T
Category	Portable Generator
Language	English