8
6. Automatic Shut-Off
To preserve battery life, the 2-in-1 Touch & Learn Tablet™ will
automatically go into sleep mode after approximately 45 seconds
without input. To turn the unit on again, turn a page, press the LED
button or use the Control Handle to change modes.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an
extended period of time.
4. Do not drop the unit on a hard surface and do not expose
the unit to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace
the batteries.
4. Turn the unit back On. The unit should now be ready to
use again.
5. If the unit still does not work, install a new set of batteries.
To Next Page
Loading...
Need help?
General
