LeapFrog LeapBuilders Store & Go Dump Truck - GETTING STARTED; Battery Removal and Installation

5
NOTE :
Il est conseillé de conserver ce guide des parents car il comporte
des informations importantes.
Rotate the packaging lock 90 degrees
counterclockwise.
Pull out the packaging lock and discard.
Unlock the packaging locks:
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover and use
a screwdriver to loosen the screw
and open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AAA batteries
following the diagram inside the
battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
5. Replace the battery cover and tighten the screw to secure.