4
5. Attach the Supporting Pillar to the
Electronic Panel. You will hear a snap
when the pieces are properly connected.
These pieces cannot be taken apart
after assembly.
6. Attach the Supporting Pillar to the
Spinner Base. You will hear a snap when
the pieces are properly connected.
These pieces cannot be taken apart
after assembly.
3. Place both Panel
Components B next
to the Spinner Base,
letter side up.
4. Attach the two
Panel Components
B to the Spinner
Base, using five
screws per panel.
Suitable for children up to 55 lbs./25 kg.
To Next Page
Loading...
