10
TROUBLESHOOTING
If for some reason the program/activity stops working, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit back On. The unit should now be ready to use
again.
5. If the unit still does not work, replace with an entire set of new batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department
at 1-800-701-5327 in the U.S. or email support@leapfrog.com.
Creating and developing LeapFrog
®
products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for
you to know that we stand behind our products and encourage you
to contact us with any problems and/or suggestions you might have.
A service representative will be happy to help you.
Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
DISCLAIMER AND LIMITATION OF LIABILITY
LeapFrog and its suppliers assume no responsibility for any damage
or loss resulting from the use of this handbook. LeapFrog and its
suppliers assume no responsibility for any loss or claims by third
parties that may arise through the use of this software. LeapFrog
and its suppliers assume no responsibility for any damage or loss
caused by deletion of data as a result of malfunction, dead battery,
or repairs. Be sure to make backup copies of important data on
other media to protect against data loss.
To Next Page
Loading...
Need help?
General
