4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit, use a screwdriver
or a coin to loosen the screw and
open the battery box.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
91-003510-016.indd 491-003510-016.indd 4 2021/9/1 9:47:312021/9/1 9:47:31
To Next Page
Loading...
