Learning Resources Teaching telephone - Features and Learning Objectives; Key Features; Learning Objectives; Programming and Recording Functions

2
Teach children telephone use, etiquette, and important phone numbers while having
fun!
Features
• Programmable setting for numbers • Voice recording
• Pre-recorded messages • Realistic ringtone
• Auto shuto after 60 seconds
Learn
• Important phone numbers
• Dialing 911
• Telephone etiquette (answering, speaking)
• Taking messages
The Teaching Telephone is designed so parents can program in important telephone
numbers and record messages for young children. It works like a real telephone! First,
take the receiver o the hook before you “make a call.” The receiver must be OFF the
hook for the telephone functions to work.
Program and Record Features
Program in a telephone number (up to 11 digits) and then record a message. When
the number is dialed correctly, your child will hear your message! You can change the
programmed number and record a new message again and again.
Note: If you change the programmed telephone number, it will not “clear” the
message you recorded. You can either leave the old message, or record a new one.
Programming a Telephone Number
• Press On button (light indicates power is on).
• Take the receiver o the hook and set it aside (you will hear a dial tone).
• Press and HOLD the Program button down (continue holding this button down
until you have programmed in the telephone number).
• Punch in telephone number using key pad (while still holding the program button).
• Release Program button.
• Hang up receiver.
• To check that the correct number is programmed in, lift receiver and press the #
key. The programmed number will appear on the display.
• To change the programmed number, repeat the steps above from the beginning.
Recording a Message
• Press On button (light indicates power is on).
• Take the receiver o the hook (you will hear a dial tone).
• Press and HOLD Record button
• After you hear the “beep,” start recording your message.
• Second beep tones indicate end of recording time.
• Hang up the receiver.
• Check to make sure your message is correct by lifting the receiver and dialing the
programmed number. Your message will play if the programmed number is dialed
correctly.
• To record a new message, repeat the steps above from the beginning.
911 and Operator
Press 911 on keypad to hear “emergency” message. Dial 0 to hear “operator’s”
message.
2665_TeachingTelephone_Guide_BRV2.indd 2 2/24/17 11:16 AM