INSERT BATTERIES
You will need:
4 AA batteries
Phillips screwdriver
1. Turn the Time Tracker™ over. Use the Phillips
screwdriver to turn the screw on the battery door in
a counterclockwise direction to loosen the screw.
2. Remove the screw and open the door.
3. Pull the clear tab sticking out of the backup battery
compartment to activate backup batteries.
4. Insert the four AA batteries, being careful to match
the + and – ends of the batteries to the diagram
inside the battery compartment.
5. Replace the battery compartment door and insert
the screw. Tighten the screw by using the Phillips
screwdriver to turn the screw in a clockwise
direction until secure. Do not over-tighten the screw.
2