INSERT BATTERIES
You will need:
4 AA batteries
Phillips screwdriver
1. Turn the Time Tracker™ over. Use the Phillips
screwdriver to turn the screw on the battery door in
a counterclockwise direction to loosen the screw.
2. Remove the screw and open the door.
3. Pull the clear tab sticking out of the backup battery
compartment to activate backup batteries.
4. Insert the four AA batteries, being careful to match
the + and – ends of the batteries to the diagram
inside the battery compartment.
5. Replace the battery compartment door and insert
the screw. Tighten the screw by using the Phillips
screwdriver to turn the screw in a clockwise
direction until secure. Do not over-tighten the screw.
2
PAUSING THE TIMER
1 Press both buttons at the same time to PAUSE.
2. Press the START to resume.
STOPPING THE TIMER
1. Press and hold the MENU button to stop the timer.
CHECK TIME REMAINING IN
EACH SECTION
1. Press START to display how much time is remaining
in the lit section.
2. Press START again to display total time remaining.
RESET BUTTON
If the unit begins to behave in an erratic manner, use the end of a
paper clip or similar small object to push the reset button located
in the small hole above the adapter jack.
USING AN ADAPTER
Important Note: When using an adapter with the unit, unplug the
adapter from the unit first, before unplugging the adapter from the
wall. Unplugging the adapter from the wall before you unplug it
from the unit will reset the unit and your programming will be lost.
1. Plug the adapter into the jack located on the right
side of the unit.
2. Plug the adapter into the wall.
The power adapter, Model No. LER2901, can be ordered from
Learning Resources by calling 1-888-489-9388 or through online
at www
.learningresources.com.
7
To Next Page
Loading...
