Page 4 of 10
Copyright ROMPA® Ltd
TIME TRACKER 20388, KH 1.11
To start the Timer
Having set Manual and/or Auto time, press MENU (the display will show CLOCK).
Use the buttons to choose MANUAL TIMER or AUTO TIMER and press ENTER to accept.
Press the START button to start the timer.
To Pause the Timer
Press both buttons at the same time to PAUSE. Press START to resume.
To Stop the Timer
Press and hold the MENU button to stop the timer.
To check the time remaining in each section
Press START to display how much time is remaining in the illuminated section.
Press START again to display the total time remaining.
RESET Button
Should operation become erratic, use the end of a paper clip or a pin to push the RESET
button located in the small hole above the adapter jack socket.
SAFETY
1. Always supervise the use of this product.
2. For 3 years and over.
CARE AND MAINTENANCE
1. To clean, wipe gently with a soft, barely moistened cloth.
2. Handle with care – the product should not be struck, thrown, mishandled etc.
3. Do not attempt to insert any foreign objects into the product.
4. Do not submerge in water – for use indoors, in dry environments only.
5. It is highly unlikely that the lamps will ever need changing.
6. Once this product is eventually exhausted, please dispose of it appropriately.
To replace batteries
7. Turn the product upside down. Using a small positive (cross-head) screwdriver remove
the screw that secures the battery compartment. Open the door of the battery
compartment. Pull the clear tab sticking out of the backup battery compartment to
activate the back up batteries. Insert four AA batteries, observing the polarity (+ / -)
indicated. Replace the battery compartment door and screw. Take care not to over-
tighten the screw.
8. As well as replacing the 4 AA batteries as required, you will also need to replace the 2
LR44 back-up batteries from time to time. These batteries maintain the clock and time
settings should the AA batteries lose power. The back-up battery compartment is
located inside the battery compartment (under the AA batteries). Use a small positive
(cross-head) screwdriver to remove the screw that secures the battery compartment.
Open the door of the battery compartment and remove the two LR44 batteries. Insert
two new batteries of the same specification, observing the polarity indicated. Replace
the battery compartment door and screw. Take care not to over-tighten the screw.
Battery care
9. Batteries should be changed by a competent adult.
10. Do not mix old and new batteries.
11. Do not mix alkaline, standard or rechargeable batteries.
12. Do not attempt to recharge non-rechargeable batteries.
13. Use only batteries of the correct specification.
To Next Page
Loading...
Need help?
General
