Section 1. Installation
IMPORTANT! This appliance must be left to stand in
an upright position for at least 4 hours before being
switched on for the first time.
Remove all packaging and securing tape from the
appliance.
Wash the interior of the appliance with luke warm
water containing a small amount of bicarbonate
soda (5ml to 0.5 litres of water).
Position the appliance in a dry atmosphere and
out of direct sunlight.
Do not position next to a cooker or other
sources of heat, i.e. radiator.
If positioned next to another fridge or freezer, leave a
minimum gap of 2cm between the appliances in
order to avoid condensation.
A clearance of 50mm should be left above the
appliance. If this cannot be achieved you should
ensure a clearance of 25mm is maintained on each
side of the appliance.
To Next Page
Loading...
