If using the Leckey footrests, remove the
seat from the chassis and set the seating
system upside down on a work surface.
Open up the angle of the leg supports by
releasing the two locking levers (A), shown,
and set to the maximum width. Open
the socket caps (B) and slide in the calf
supports. Set to the desired position, with
the footplates facing forward and retighten
the socket cap bolts with the multi-tool.
Always make sure the foot plate is
attached firmly.
7.2 Attaching the
footrests (if ordered)
A
B
B
To Next Page
Loading...
