7.18 Interfaces for wheelchair and
pushchair bases
The set up and attachment of the Mygo
seat to any mobility base should be
completed by a technically competent
person who is familiar with the set up of
the mobility base.
Interface “A” attachment to 16” wide
mobility base
The universal interface has been designed to
enable the Mygo Seat to be attached to any
standard 16” (405mm) wide mobility base
that has been constructed from 1” (25.4mm)
side tubing.
Please refer to specific assembly instructions
supplied with your interface for correct
positioning on your base.
The Interface plate should be fitted by a
qualified technician who is technically
competent in the set up of the mobility base.
The position of push handles, leg hangers and
armrests on the mobility base may need to be
adjusted depending on the size and weight of
the child to ensure the stability of the seat.
Always refer to the mobility base
manufacturer’s guide lines for correct
set up, paying particular attention to
product centre of gravity and stability.
Users should not be left unattended at
any time whilst using Leckey equipment.
To Next Page
Loading...
