9.10 Lateral support
padded cushions
9.11 Shoulder support
cushion (if applicable)
To attach the lateral support padded
cushions, simply slide the cushions on with
the padded side towards the inside of the
seat. Feed the plastic buckle through the
slot in the cover, then bring the two Velcro
fastener straps around the bottom of the
moulding and attach them to the Velcro
panel as shown. Close over the flap.
First loosen the shoulder support laterals
(see section 10). Slide the cushion over the
assembly and secure using snap fasteners
(A) in four places.
A
A
A
A
To Next Page
Loading...
