LECTRICEBIKES.COM | 602.715.0907 18
Charge Battery Before First Use
Locate charging port on the side of the battery pack. Use this port to
charge when battery pack is installed or not installed.
You should fully charge your battery before your rst ride.
Fire and explosion hazards. Never leave your battery pack
unattended while charging to prevent serious injury or death.
See Battery Pack section (p. 36) for additional information.
Front and back adjustment: Loosen nuts on both sides of the seat.
Make sure the clamp mechanism is clamping on the straight part
of the seat rails and is not touching the curved part of the rails.
Ensure that you are using the recommended torque on the clamping
fastener(s). See Tightening Torque (p. 19).
Seat angle adjustment: Most people prefer a horizontal seat; but
you may prefer the seat nose angled slightly up or down. Loosen
the clamp bolt to allow any serrations on the clamp mechanism to
disengage before changing the seat angle, and to fully re-engage the
serrations before you tighten the clamp bolt to the recommended
Tightening Torque (p. 19).
To Next Page
Loading...
Need help?
General
