Need help?Do you have a question about the Lectron Level 1 EV Charger for J1772 and is the answer not in the manual?
General| Connector Type | SAE J1772 |
|---|---|
| Charging Level | Level 1 |
| Input Voltage | 120V AC |
| Output Current | 16A |
| Cable Length | 21 feet |
| Output Voltage | 120V AC |
| Power Output | 1.92 kW |
| Operating Temperature | -22°F to 122°F (-30°C to 50°C) |
| Compatibility | All J1772 EVs |
| Safety Features | Over-current, over-voltage, short-circuit, and over-temperature protection |
| Certifications | UL Listed |
Table detailing voltage and current for 5-15 and 14-50 plugs.
Insert the plug into a powered wall outlet.
Mobile connector display shows 3 LEDs and blinking ring when ready.
Plug the charging handle into your vehicle's charging port.
Charging starts automatically; LEDs and ring indicate activity.
Fully charged status indicated by blinking LEDs and solid outer ring.
Remove the charging handle from your vehicle.
Addresses issues where the mobile connector display does not turn on.
Solutions for when the vehicle fails to charge or shows a solid fault indicator.
Troubleshooting steps for a blinking fault indicator, including utility or temperature faults.
Details the color and blinking patterns of LEDs for various states like charging, complete, or errors.
To Next Page
