2
Thank you for purchasing our product. This RGB LED
controller is designed to drive constant voltage LED products
with common anode connection in voltage range of DC5V-24V.
It contains a main control unit and a remote controller. User can
setup dozens of dynamic program and static color via the
remote.
10. Power Supply
The controller unit can work from DC 5V to 24V. The red
power cable should be connected to power positive and black
to negative. Please make sure the power supply voltage is
same as the LED load and the power is capable for the load
wattage.
RGB LED Controller
User’s Manual
43 Dynamic Modes
30 Static Colors
Full Protection
RF Remote Controller
Waterproof Option
Easy Remote Pairing
Direct Color Select
Demo Dynamic Mode
Introduction
Installing
11. LED Output
The controller unit supports constant voltage driving LED
products with common anode connection. The black cable
on the output side is the common node, it connects to the
power supply positive inside the controller. The green, red
and blue cable runs the driving signal of relevant LED color,
please connect the color cables to the cathode of relevant
color LED loads and the black cable to the common node.
The controller unit has output overload protection
function, please check whether the output is short circuit or
over loaded if the controller stop working.
1
2
6
3
4
5
7
8
9
12
Functions
1. Turn On/ Standby
Press ‘I’ key to turn on unit or press ‘O’ key to turn off. At power
up moment, unit will automatically turn on and restore to
previous status .
2. Switch Dynamic Mode
Switch between dynamic modes or switch to dynamic mode
from static color.
3. Play / Pause
At dynamic mode, press this key to toggle run or pause mode.
At static color mode, press this key will switch to dynamic mode.
4. Dynamic Speed Adjust
Adjust dynamic playing speed. Press SPEED+ to increase speed
and press SPEED- to decrease. Unit will switch to dynamic
mode If press this key at static color mode.
5. Demo Mode
Press this key will switch to Demo mode. At demo mode, it
runs 27 dynamic modes in loop, each mode repeat for 3 times.
6. Switch Static Color
Switch between static colors in loop. When press this key at
dynamic mode, it will switch to static color mode.
7. Brightness Adjust
Adjust static color brightness. Press BRIGHT+ to increase
brightness and press BRIGHT- to decrease. Unit will switch to
static color mode If press this key at dynamic mode.
8. Direct Color Select
Shortcut keys to static color. When press the specific color
key, LED will play the same static color. The direct colors are
included in ‘COLOR+’ and ‘COLOR-’ key operation.
9. Remote Controller Indicator
This blue indicator will blink when remote controller works.
Hints: The remote controller works at radio frequency, the
signal can pass through barrier, so it’s not necessary to aim at
the controller when operate the remote.
10
11
To Next Page
Need help?
General
