NOMAL OPERATION
WITH MULTIPLE REMOTE CONTROLLER INSTALLED
1. Press the ON/OFF button. Then ensure the
priority lamp is lit on the remote controller and
the set temperature is displayed on the each
remote controller.
2. Set temperature which you need. (The
temperature setting can be changed by only
priority unit. If you desire to transfer the
priority setting, you can transfer it by
pressing PRIORITY button only if no water
flow.)
When adjust the set temperature with MC100-
AU3, it allows the output temperature from the
water heater to be adjust within the range of
37ºC to 55 º C. And When adjust the set
temperature with SC100-AU3 and FC100W-
AU3, it allows the output temperature from the
water heater to be adjust within the range of
37ºC to 50ºC.
NOTE: Each remote controller can individually
store the temperature setting. However –
＜ MC100-AU3 ＞
When the priority setting is transferred to
MC100-AU3, if the previous temperature
setting which stored in MC100-AU3 was
55ºC, it become to 50℃.
＜ FC100W-AU3 , SC100-AU3＞
When the priority setting is transferred to
FC100W-AU3 (or SC100-AU3), if the
previous temperature setting which
stored in FC100W-AU3 (or SC100-AU3)
was 43ºC and above, it become to 42ºC.
3. Open a hot water tap, and ensure the BURNER
ON lamp is lit. Mix cold water with the hot if you
need.
4. Close the hot water tap, and ensure the
BURNER ON lamp is OFF.
Water temperatures above 70 ℃ can cause severe burns or death from scalding.
Children, the disabled and the elderly are at a high risk of being injured. Feel the water
temperature before bathing or showering. Do not leave children, disabled persons, or
the elderly unsupervised. The Australian Standards AS 3498 gives full details of the
requirements for supply of controlled temperature to ablution outlets (bathrooms) and
is required to be conformed to under all plumbing codes within Australia.
To Next Page
Loading...