Section 2
SPECIFICATIONS
2-7
785 Motor Grader
TABLE 2-13. TORQUE SPECIFICATIONS FOR METRIC FASTENERS
WARNING: The following Table lists torque values for standard hardware and are intended as a
guide for average application involving typical stresses and machined surfaces. Values
are based on physical limitations of clean, plated and lubricated hardware. In all cases,
when an individual torque value is specified, it should be followed instead of values
given in this table.
CAUTION: Replace original equipment with hardware of equal grade.
NOMINAL SIZE CLASS 8.8 CLASS 10.9
& PITCH [GRADE 5 EQUIVALENT] [GRADE 8 EQUIVALENT]
TORQUE FT. LBS. TORQUE N•m TORQUE FT. LBS. TORQUE N•m
Dry Lubed Dry Lubed Dry Lubed Dry Lubed
M4 x 0.7 2.27 1.70 3.07 2.30 2.27 2.31 4.17 3.13
M5 x 0.8 4.58 3.43 6.20 4.65 6.22 4.67 8.43 6.33
M6 x 1 7.75 5.83 10.5 7.90 10.60 7.97 14.3 10.8
M8 x 1.25 18.89 14.17 25.6 19.2 18.95 19.26 34.8 26.1
M10 x 1.25 39.11 29.52 53.0 40.1 53.87 40.59 73.0 55.0
M12 x 1.75 64.94 48.71 88.0 66.0 88.56 66.42 120.0 90.0
M14 x 2 103.32 77.49 140.0 105.0 140.22 107.01 190.0 145.0
M16 x 2 162.36 121.77 220.0 165.0 221.40 166.05 300.0 225.0
M20 x 2.5 317.34 236.16 430.0 320.0 428.04 321.03 580.0 435.0
M24 x 3 516.12 409.59 740.0 555.0 754.38 557.19 1010.0 755.0
M27 x 3 797.04 597.78 1080.0 810.0 1084.86 811.80 1470.0 1100.0
M30 x 3.5 1084.86 811.80 1470.0 1100.0 1476.00 1107.00 2000.0 1500.0
Courtesy of Machine.Market
To Next Page
Loading...
