- Go back to the XConsole software. At the top of the screen click “Setup” then “Port Connections” This bring up a new
dialog box. Select the COM port number you obtained from the device manger and click “OK.” The software will warn
you that you must restart the software for your changes to take effect.
- Restart the XConsole software. This time, when it asked “Do you want to connect to the device?”, answer “Yes”.
- You should now be connected to the device and ready to use.
Room Equalization
Before making adjustments with your processor, a basic understanding of parametric and graphic equalization is needed.
Parametric filters allow you to control the three primary parameters of a useful band-pass filter. These parameters
are amplitude (boost or cut), center frequency (pitch) and bandwidth (tonal range). Bandwidth is typically labeled "Q" on the
unit, which stands for Q factor. The amplitude of each band can be controlled, and the center frequency can be shifted, and
widened or narrowed.
Simpler graphic filters are fixed in frequency and bandwidth, so the music spectrum is divided into uniform third-octave spac-
ings.
Wave Launch Processor
To Next Page
Loading...
Need help?
General
